Entrar no Modo monitor Tp-link Archer T2U Nano Ajuda!

Bemvindoao2020
(usa Kali)

Enviado em 11/08/2020 - 21:46h

Peesoal,

Preciso da ajuda de vocês para entrar no modo monitor deste adaptador wireless.
Estes são alguns comandos e Respostas que tive sem sucesso

sudo iwconfig
lo no wireless extensions.

eth0 no wireless extensions.

wlan0 unassociated ESSID:"" Nickname:"<WIFI@REALTEK>"
Mode:Managed Frequency=2.417 GHz Access Point: Not-Associated
Sensitivity:0/0
Retry:off RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=0/100 Signal level=0 dBm Noise level=0 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0

sudo airmon-ng start wlan0

Found 2 processes that could cause trouble.
Kill them using 'airmon-ng check kill' before putting
the card in monitor mode, they will interfere by changing channels
and sometimes putting the interface back in managed mode

PID Name
383 NetworkManager
618 wpa_supplicant

PHY Interface Driver Chipset

phy0 wlan0 rtl88XXau TP-Link 802.11ac WLAN Adapter

Newly created monitor mode interface wlan0mon is *NOT* in monitor mode.
Removing non-monitor wlan0mon interface...
Segmentation fault

WARNING: unable to start monitor mode, please run "airmon-ng check kill"

sudo airmon-ng check kill

sudo airmon-ng start wlan0


PHY Interface Driver Chipset

phy0 wlan0 rtl88XXau TP-Link 802.11ac WLAN Adapter

Newly created monitor mode interface wlan0mon is *NOT* in monitor mode.
Removing non-monitor wlan0mon interface...
Segmentation fault

WARNING: unable to start monitor mode, please run "airmon-ng check kill"

Alguem pode me ajudar?